Valkyrie PRIMO 100

1 VIAL 10ML BY VALKYRIE PHARMACEUTICAL

DOSAGE : 100mg/ml Methenolone

Primobolan Enanthate Steroid Profile

Methenolone enanthate is an adjusted form of the Primobolan substance that allows for injection of the compound, rather than the more common oral ingestion.

At a basic level, this substance is an offshoot of dihydrotestosterone, or DHT, with further adjustments of an additional double bond between the 1st and 2nd carbon position. It also contains an added 1-methyl group. 

This added methyl group is useful in preventing breakdown of the compound by the liver during digestion.

All of this makes for a compound with no estrogenic effects, that has a low androgenic profile but a moderate anabolic profile.

Primobolan 100 is a form of the drug that provides a 100-milligram dose for every 1 milliliter of oil-based solution, which makes it a good choice for those searching for the substance to use it in physique improvement or performance enhancement.

This drug acts in the body in a similar way to all other similar substances, through acting on androgen and secondary receptors to cause a boost in protein production and retention in the body. It may also help increase satellite cell content in the muscle.

This form also offers Primo injection delivery, allowing athletes to inject the drug directly, which can allow for faster delivery to the body.

Also, with an enanthate ester acting as a relatively slow release agent with a half-life of approximately 10 days, this can also reduce the amount of injections needed to maintain high circulating levels in the body.

This can then reduce the risk of injection-related issues such as soreness and injection site infections.

Overall, the adjustments to this compound make for a unique drug that can have a beneficial place in an athlete's training and nutrition regimen.

What Is Primobolan For?

This compound was, like most other related substances, was created for therapeutic use, with the treatment of growth deficiencies or its use to promote lean tissue growth after debilitating illnesses or surgery.

But, the increased use of these substances in athletic circles eventually led to its inevitable use in sport and bodybuilding.

Because Primobolan has a relatively low anabolic and androgenic rating, it is not commonly used on its own, or in training phases where the goal is to accumulate as much mass as possible.

Primobolan 100 mg is also a relatively low dose for male athletes who are looking to improve their sporting performance or their physique, as common doses have been reported to be in the 200-400 milligram range, with doses as high as 600 milligrams reported.

However, this drug and its dose would be especially useful to female athletes, due to its low risk of virilisation (the development of male traits: a square jaw, a deep voice, facial hair or clitoral enlargement).

This is due to Methenolone’s low androgen profile and moderate anabolic effects, which makes it a far more female-friendly substance than other similar compounds.

The more friendly nature of this compound also means that it can be used for longer cycles than more high-impact substances.

For many cycles, the average timeframe is 6 to 8 weeks of use for any one drug. However, in this case, it may be possible to store h the use of this substance out to 12 weeks or perhaps longer. This makes it a very useful compound for “off-season” cycles, where the objective is to slowly accumulate mass over a longer time period.

It may also have some use for smaller athletes or those who are inexperienced in steroid use, if they are looking to maintain as much lean mass as possible when reducing weight, or for inexperienced users trying to only promote size increases through lean tissue growth. 

How To Inject Primobolan Depot

As mentioned above, one of the biggest differences with Methenolone enanthate is that it can be delivered through an intramuscular injection.

As such, a Primobolan injection is delivered through an intramuscular injection in a number of sites, including the most popular lateral deltoid, or side shoulder, glutes, or buttocks, and, in some cases, the thigh. This is done using a sterile hypodermic syringe.

It should be noted that, before injecting Methenolone, you should always consult a qualified medical professional to ensure the correct technique and procedure is followed.

Methenolone Enanthate Dosage

As stated previously, a Primo 100 mg dose would be considered a relatively conservative dosage for either aesthetic use or to boost performance for most male athletes. But, it would still be suitable for females or complete beginners.

For Methenolone Enanthate, a dose of 200-600 milligrams has been reported as common dosages for male athletes.

This seems to be the case for both cutting and lean bulking cycles. But, it should still be noted that higher doses of the compound will raise the chances of adverse events, even in this relatively side-effect-friendly drug.

So, if you’re looking to use Primobolan when cutting mass, a dose of 200-300 milligrams should suffice. However, if you’re using this compound to raise your size, then a higher dose of 300-600 milligrams can be used.

Negative Effects of Methenolone Enanthate

The Primo steroid is known as one of the most adverse-effect-friendly substances available for performance enhancement. It has no oestrogen-related effects on the body, holds no hepatotoxicity and has a very low androgen profile.

However, like in all of these substances, there is still a risk of some adverse effects occurring.

While the Methenolone Enanthate 100 mg dosage will present very few adverse events in all but a very few sensitive individuals, the use of higher doses, alongside irresponsible or prolonged use can increase chances of these occurring.

The adverse effects associated with Primobolan 100 can include:

• Androgenic effects – these effects include oily skin and acne, virilisation, as explained above, and the acceleration of male-pattern baldness in those who are genetically predisposed.
• Cardiovascular effects – these include the concurrent increase of unhealthy Low Density Lipoprotein cholesterol and reduction in High Density Lipoprotein cholesterol. This is accompanied by a potential reduction in blood vessel flexibility and an increased heart size. But, these effects are milder than most other substances.
• Endogenous testosterone suppression – As with all other similar substances, the use of this product will reduce the natural production of your testosterone levels. So, this means this hormone should be supplemented while on a program using this compound.

It should also be noted that, while the risk of any serious androgen-related adverse effect is extremely low, these events can be managed with the addition of a 5-alpha reductase inhibitor such as anastrozole into your drug regimen.

But, overall, this compound is one of the friendliest substances to take for those looking to boost their sports proficiency or their physique.

Methenolone Enanthate vs. Acetate – What’s The Difference?

Despite the above form of this compound being the most common kind of Primobolan injection, there is also a form of Primobolan that has an attached acetate ester, which is an acetic acid attachment that acts as a faster chemical delivery agent.

Methenolone Enanthate, as mentioned above, has an active half-life of roughly 10 days. However, the addition of an acetate ester instead gives the substance a much shorter half-life of around 3 days.

This means that a Methenolone Enanthate 100 mg injection can be used for a more sustained release of the drug with a lower injection frequency, whereas the acetate  form of the compound may be useful in maintaining a high level of the substance in the bloodstream. 

So, if you’re using a low dose of the drug, or are in a cutting phase of your training, then the acetate form may be a more useful substance.

But, if you are looking at using this drug in a lean bulking phase, or if you are using higher doses, particularly if you’re sensitive to injection-related issues, then you may have an easier time including it if you’re using the enanthate variant.